Draytek Vigor 2200V Instalační příručka stáhnout pdf (Strana 32)

2-11

Installation & Setup

5. Make the “New gateway” and “Installed gateways” fields

blank and click “OK”. A dialog box will pop up asking you to

restart the PC. Click “Yes”.

2.3.3 Checking TCP/IP settings

1. After completing the previous steps, click “Start” -> “Run” ->

and type “winipcfg”. The IP Configuration window will open. If

the PC does not show an IP address in the 192.168.1.2 to

192.168.1.254 range, click the “Release” button to release the

current configuration. Wait a few seconds and click “Renew”

to get a new IP configuration from the router.

2. If the IP configuration is correct, you will be able to use the

PING diagnostic utility built into Microsoft Windows to ping the

router. Click “Start” -> “Programs” -> “MS-DOS Prompt”. A

a command mode window will open. Type “ping 192.168.1.1”

(default IP of the router) to check the network connectivity. If

both hardware and software are correct, your computer will re-

ceive a response from the router as shown on the next page. If

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 139 140

Žádné komentáře

Draytek Vigor 2200V Instalační příručka Strana 32